6 comments

• 

  Byron

  1 year ago

  On the note of the center created rectangle, the ability to create constrained rectangles on odd angles!
  *smack head* FINALLY!
  very useful when creating some of these goofy shaped plastic components.
  reply
• 

  Ulrich Hanisch

  1 year ago

  Here are two functions which are missing and probably available in SWX 2011 :-)
  
  - DRW table with tolerances corresponding to the precision settings in the PRT dims
  - legend / caption for all surface finish symbols used in a DRW
  
  But i agree: mid centered rectangle has a lots of the well known FINALLY effect !!
  reply
• 

  Ricky Jordan

  1 year ago

  Byron,
  
  You are right, the 3 Point Corner & 3 Point Center Rectangle commands will come in handy as well! It's nice to have some options now.
  
  Best Regards,
  
  Ricky Jordan
  reply
• 

  Ricky Jordan

  1 year ago

  Ulrich,
  
  Ben Eadie has started a wish list at the SolidMentor website. Make sure you add these suggestions to the list. Here is the link: http://solidmentor.com/modules/Wish_list/
  
  Also don't forget to fill out that enhancement request!
  
  Thanks for reading!
  
  Best Regards,
  
  Ricky Jordan
  reply
• 

  Tina

  1 year ago

  I have a problem when inserting a picture to the drawing. It shows alright after I insert the picture. However, I save the file, close it, and then open the drawing again, the picture is not showing. Have you encountered such problem? Is there anyway I can solve it?
  
  Thanks a lot.
  reply
• 

  Greg

  1 year ago

  I am really disappointed with 08. I think it has more bugs in it than windows vista ever did.
  
  The new command manager drives me crazy.
  reply